Gift Candle

Print

Method

1. Weigh your soy wax. Add soy wax to a pouring pitcher, glass pyrex jug, stainless steel jug or old pot and melt the wax using the double boiler method (see below) You may need to do this in two batches if your jug isn’t big enough. Though you can usually start melting the wax and then add more as it’s melting.
2. Using the thermometer heat wax until 85C, stirring occasionally. If using colour grate this in now.
3. Add in your fragrance to this and stir thoroughly but gently.
4. Take the jug out of the double boiler and sit aside (on a heat resistant surface) until the temperature comes down to 65C.
5. While the wax is cooling, use the wick sticker to attach wick to the container making sure it is centred.
6. Stir the wax again at 65C then pour slowly into the jar. 
7. Use the wick bar to centre the wick. Sprinkle with Bio Glitter.  Just before wax is set you can add a little dried flowers.
8. While the jug is warm, clean out with paper towels and a little isopropyl alcohol (if you have it).
9. Let the candle cool overnight, then trim the wick to 6mm (do this also each time you light it). Let the candle cure for a minimum of 48 hours but ideally up to 2 weeks.  The longer curing time will improve hot and cold scent throw of your candle.

Enjoy!

Double Boiler Method

Fill a saucepan with a third of water, bring to the boil and reduce to a gentle simmer. Place the wax into a pouring pitcher, tempered glass or stainless steel jug small enough to fit inside the saucepan and is best if the handle from jug goes over the outside of the pot.  Carefully place the bowl onto the simmering water. Stir wax every now and again as it melts.

Copyright, PureNature. This information is intended for personal use of PureNature customers and may not be reproduced, shared or used for commercial purposes without written consent.